Why Cable Length Means the Round Trip
Count both wires, not one. A low-voltage device sits in a loop, so current goes out on the positive cable and comes back on the negative. Wikipedia says the drop happens in both the supply and the return wire.1
The loop
Picture a fridge 6 metres from the battery. You run one cable to it and one cable back. The current travels 6 metres out and 6 metres home, so 12 metres of copper carries it.2
Each cable drops some volts. The device sees the battery voltage minus both drops. That's why a sum based on only one wire gives a result that's too small.
What the makers do
Victron's cable table uses the total cable length, which is the length of the positive cable plus the length of the negative cable.2
Its app does the same job. Once you enter the voltage, cable length, current and cross-section, the app calculates the voltage drop over both cables.2
An example in numbers
Victron works through an inverter on a 12V battery. The current is 200 amps, and each cable has a resistance of 0.0016 ohms.3
The drop over one cable is 200 × 0.0016, which is 0.32 volts. Since there are two cables, the positive and the negative, the total voltage loss is 0.64 volts.3
So the inverter doesn't get 12V. It gets 12 − 0.64, which is 11.36 volts.3
If you'd counted only one cable, you'd have said 0.32 volts and underestimated the loss by half.3
A common mistake with one-way length
People often measure the cable they can see: the path from the battery to the device. That's the one-way length. For the sum, double it.
| One-way distance | Total cable length used in a chart or sum |
|---|---|
| 2 m | 4 m2 |
| 5 m | 10 m2 |
| 7.5 m | 15 m2 |
| 10 m | 20 m2 |
The doubling is because Victron's table uses the total cable length, the length of the positive cable plus the length of the negative cable.2 Of these totals, 10, 15 and 20 m are Victron's column limits. The 4 m total falls in the "up to 5 m" column.
What if the negative isn't a separate cable?
Some vehicles and trailers use the metal chassis as the return path. This site hasn't saved a source on how that affects the sum, so read your device's manual and your vehicle maker's wiring notes. A shared return still has resistance, and the voltage drop applies there too.1
Putting it together
Use the round-trip length every time you open a cable chart. The full sum is on the calculation page.
A second worked case
Try a 12V light 3 metres from the battery. The round trip is 6 metres.2
Victron's table puts a 1.5 mm² cable at 4.5 amps for up to 5 metres of total cable, and 2.3 amps up to 10. Six metres falls in the second column, so the 2.3 amp figure applies. A light drawing 1 amp sits well inside that.2
The point isn't the number. It's that using 3 metres instead of 6 would have placed the light in the wrong column of the chart.2
Cited material
- Voltage drop, Wikipedia
- Wiring Unlimited: DC wiring (cable selection), Victron Energy
- Wiring Unlimited: Theory (current, cable resistance and voltage drop), Victron Energy