What Is Voltage Drop on a 12V Circuit?
Voltage drop is the voltage the wire itself uses up. Your battery might sit at 12 volts, but the light at the far end of a long cable gets a little less. The missing volts didn't vanish. They were spent pushing current through the cable.1
Think of a garden hose. The tap puts out a certain pressure, but a long, thin hose delivers less at the nozzle than a short, wide one. Voltage is the pressure. The cable is the hose.
What the term means
Wikipedia describes voltage drop as the decrease of electric potential along the path of a current flowing in a circuit. In plain words, voltage falls as current travels along a wire.1
That lost voltage turns into heat in the cable. The load, such as a fridge or LED light, only gets what's left.1
Why a cable uses up voltage
Copper is a good conductor, but it isn't perfect. Every cable has some resistance, which is a measure of how hard it is for current to pass. Two things change that resistance, and they're easy to remember.2
- A thin cable has a higher resistance than a thick cable of the same length.2
- A long cable has a higher resistance than a short cable of the same thickness.2
A third thing is the current itself. Victron's wiring book says an increased current will increase the voltage drop, and the cable will heat up more. So a fridge that draws more amps when its compressor starts loses more volts than a small light does on the same wire.2
The return wire counts too
A 12V circuit is a loop. Current goes out on the positive wire and comes back on the negative one. Wikipedia notes that voltage drop exists in both the supply and return wires of a circuit.1
So the total loss is the loss in both wires added together. The next pages show how to work that out, and a separate page on measuring length covers the length question.
A quick example
Say a battery sits at 12 volts and a cable run loses 0.5 volts in total. The fridge at the end sees 11.5 volts. That may be fine for one device and a problem for another, because each device has its own lowest working voltage. The maker's manual is the place to check.1
Low voltage at the end of a run can also cause trouble beyond a dim light. Victron lists some effects of high voltage drop in a system. Batteries can be undercharged during charging, and the cable heats up.2
How to cut the loss
Wikipedia says the simplest way to reduce voltage drop is to increase the diameter of the conductor between the source and the load. A thicker cable has less resistance.1
You can also shorten the run. Victron's list of ways to prevent losses includes keeping cables as short as possible and using cables with sufficient thickness.2
Both fixes show up again in later pages. One gives the sum itself, and another covers the limits people aim for.
Where this site stops
This site is about low-voltage wiring only. Mains wiring is a different job. In Australia, fixed mains wiring is licensed work, so call a licensed electrician for that.
Cited material
- Voltage drop, Wikipedia
- Wiring Unlimited: Theory (current, cable resistance and voltage drop), Victron Energy