Skip to content

How Much Voltage Drop Is Acceptable?

Up to date as of 18 November 2026

There's no single number that suits every 12V device. One wiring maker advises aiming for no more than 2.5 per cent. Codes and device manuals can differ, so the strictest applicable limit wins.1

What a maker advises

Victron's wiring book says opinions vary somewhat, but it advises aiming for a voltage drop no bigger than 2.5%. In its own table, that's about 0.3 volts on a 12V system.1

Its DC wiring chapter says the same thing in other words: you should aim for a voltage drop below 2.5%.2

That figure is a target, not a legal limit. It comes from one maker's guide for battery-based systems, so treat it as a starting point for your own wiring.

Why the limit exists

A drop wastes energy. Victron's example is a 1000 watt load: with a 2.5% drop, 2.5% of the power is lost as heat in the cable, which is 25 watts.2

There are other effects. Victron's list of the downsides includes batteries being undercharged when voltage drops during charging.1

Codes differ by country

Wikipedia says national and local electrical codes may set guidelines for the maximum voltage drop allowed in electrical wiring. It adds that the permitted drop varies from one country to another.3

So a rule that applies in Australia may not apply in the United States, the United Kingdom or New Zealand. This site can't tell you which local rule covers your build. Victron's list for preventing voltage loss ends with a simple line: follow wiring legislation.1

Deciding if a drop is acceptableRead the device's own manualCheck any local wiring rulesUse a maker's guide as a fallbackChoose a cable that meets the lowest limit
Start with the device's manual, then check any rules that apply.

Where the device's own manual comes in

Every light, fridge and charger has a working voltage range, and it differs between models. The maker's manual or spec sheet is the place that states it for yours.

Many makers also state a cable size for their product. Victron says to find the correct cable thickness in the product manual.2

Turning a percentage into volts

A percentage of 12 is easy to work out. Victron's table gives 0.3 volts as 2.5% of a 12V system.1

System voltage Percentage Voltage drop
12V 2.5% 0.3 V1
24V 2.5% 0.6 V1
48V 2.5% 1.2 V1

The percentage is measured against the supply voltage. The same share is fewer volts on a 12V system than on a higher-voltage one.1

Putting it to use

  1. Look up the device's manual for a minimum voltage or a recommended cable size.
  2. Find out whether a wiring rule applies where you live.3
  3. Pick a drop limit, with 2.5% as Victron's advice if nothing else is stated.1
  4. Test your cable against it, using the step-by-step sum or a size chart.

If a result lands close to the limit, choose the thicker cable. The drop will be smaller. Mains wiring is a separate matter, and in Australia fixed mains work needs a licensed electrician.

Cited material

  1. Wiring Unlimited: Theory (current, cable resistance and voltage drop), Victron Energy
  2. Wiring Unlimited: DC wiring (cable selection), Victron Energy
  3. Voltage drop, Wikipedia