Skip to content

Voltage Drop Between Solar Panels and the Controller

Up to date as of 18 November 2026

The same rule applies to the cable from your panels: a longer, thinner run loses more voltage. What can change is the voltage on that cable. Victron says a 12V solar panel has an open-circuit voltage of around 22V, and panels connected in series add up to a higher array voltage.1

Where this cable sits

A solar charger, also called a charge controller, sits between the panels and the battery. Victron says a solar charger needs to be placed between the solar panels and the batteries.1

Wikipedia notes that in solar applications, controllers may also be called solar regulators or solar charge controllers.2

The solar runSolar panels make powerCable carries it to the controllerController charges the batteryBattery feeds the 12V circuits
Voltage drop applies on the cable between panels and controller too.

So there are two separate cable runs. One goes from panels to controller. The other goes from controller to battery. Each has its own length, current and drop.

Why a higher-voltage array may allow thinner cable

Victron says that if a DC system voltage is increased, the current will drop, and the cables can be thinner.1

Its theory chapter says the same in terms of voltage drop: generally speaking, the higher the voltage of the circuit, the lower the voltage drop will be.3

Wikipedia describes this for a charge controller with MPPT capability, which lets a higher-voltage array charge a lower-voltage battery. There, higher array voltage means lower array current, and considerable efficiency gains can be achieved, particularly when the PV array is located at some distance from the battery.2

So a lower current may allow thinner cable, but the cable size still has to be checked against the panel's current and the maker's manual.

A rough example shows the idea. A 120 watt load at 12 volts draws 10 amps, because watts divided by volts gives amps. The same power at 24 volts draws 5 amps. Half the current gives half the volts lost in the same cable.3

Same sum, different numbers

The sum doesn't change. Work out the round-trip length of the cable, find its resistance, and multiply by the current. The steps are on How to Calculate Voltage Drop Step by Step.3

Two points to watch:

  • Use the current the panels actually send down the cable, which is on the panel's label or the maker's data sheet.
  • Compare the drop with the panel voltage, not with 12 volts. A 1 volt loss is a smaller share of a higher voltage.3

The percentage a controller maker accepts is stated in its manual. Check it for your model rather than relying on a general figure.

Solar cable and connectors

Panels usually come with leads ending in special waterproof plugs. Victron says that MC4 connectors can be connected to 4mm² or 6mm² solar cables.1

So if you're extending a panel lead, the size you can fit may be limited by the plug. Check the connector's own data sheet and your panel's manual.

If the lead is too short, Victron says an extension cable will need to be used, often pre-assembled with MC4 connectors.1

Safety and rules

Solar panels make voltage whenever light hits them, so the cable is live in daylight. Victron notes that, depending on local regulations, a fuse, circuit breaker, RCD or GFCI might need to be installed between the PV array and the solar charger.1

Victron also says that higher voltage means insulation needs to be thicker or better, and cables are rated for a maximum voltage.3

Rules differ by country. Anything that connects into household mains wiring is work for a licensed electrician in Australia. This site covers low-voltage DC wiring only.

For the controller-to-battery side, use the method on the cable chart page.

Cited material

  1. Wiring Unlimited: DC wiring (solar), Victron Energy
  2. Charge controller, Wikipedia
  3. Wiring Unlimited: Theory (current, cable resistance and voltage drop), Victron Energy